At t 2wire Dsl Router Setup 5 Static Ip Addresses

By Nils Hyatt

Have you ever just purchased a business dsl plan from At&t, which incorporates 5 static ip addresses and wish to learn to set them as much as avoid paying a $200 charge. The very first thing that you are going to need to do is find out what your default gateway ip address is on your 2wire dsl router. The easiest option to find your default gateway ip is to go to the cmd prompt and sort in 'ipconfig'. Yow will discover the command immediate by going to the beginning button -> All Programs -> Accessories -> Command prompt. After the command prompt window opens, this is where you will sort in ipconfig. (See Example Under) When you sort in 'ipconfig' you need to see some results, that is where you can see what your default gateway. For example my default gateway is 192.168.10.

The following factor you need to do is type you default gateway handle into an internet browser, comparable to Internet Explorer or Mozilla Firefox. After you kind your default gateway ip deal with into your internet browser, you should get a display screen that looks just like the one below.

Once you have opened the configuration display in your 2wire dsl modem, you will want to click on on the broadband hyperlink tab The broadband link tab is positioned close to the highest of the screen.

Upon getting accessed the broadband link tab, you´ll then click on on Advanced setting situated throughout the broadband link tab. Inside the advanced setting window, you will change your username slightly. What you will need to doing is change USERNAME@sbcglobal.web to USERNAME@static.sbcglobal.net. Then click on the save button. (Consult with the picture under)

After a couple of minutes your router should be executed configuring itself from its normal dynamic ip to a static ip. What you´re going to need to do now could be configure your router, so you possibly can assign completely different static ip addresses to your different community devices. The first thing you will do is click on on the Residence Network tab, positioned at the high of the screen.

You´re going to then click on the Advanced Setting tab located throughout the Dwelling Network tab. As soon as you are on the advanced setting web page, locate the Bridge Community setting and click enable. For the subnet mask I used 255.255.255.248. After you click save, you´re then going to want to click on Edit Handle Allocation tab. Within the edit address allocation settings web page you´ll be able to assign completely different static ip address to your different servers, pc and different networked devices.

When you click save on the edit deal with allocation tab, you´re going to now have to configure every device to receive a static ip address. On a home windows based mostly laptop, simply go into the command immediate window and sort in 'ipconfig /release' then sort in 'ipconfig /renew'. If you´re using Vista, you´re going to need to run command immediate as administrator. Are you searching for extra info on establishing your 2wire dsl modem.

Article Source: http://interpret.zar.vg