How To Check And Modify Your Own Ip Address In Windows Vista

By Sameh Abdelhady

- Check an IP Address in Windows Vista:

1. Start off Windows Vista and sign on to your account. If you are the only user of the pc then your own computer will automatically load to your account, as well as you will certainly have administrator privileges to be able to check or change an IP address.
2. Check to make sure that you have an active connection to the Web. You won't be able to check an IP address working with Windows Vista without having access to the Web.
3. Go to the IPlocating.com web site to figure out your present IP address (look at Resources below). Once the page loads, you will immediately view a display of your current IP address.
4. Adjust your IP address manually by making use of the Windows Vista Network and Sharing Center. Click "Start" after that "Control Panel" and double-click on the "Manage network connections" link.
5. Simply click the "Network" tab. You will certainly notice that Windows Vista is set to "Automatically assign an IP address."
6. Click the "Use the following IP settings." That will probably allow you to change the configurations to your very own specific needs.
7. Input all of the needed IP Address data, including the IP address, Subnet mask and Default gateway. The system administrator and/or the network administrator will certainly have this data.
8. Click "OK" once you have finished.
9. Try out to go back to IPlocating.com to verify if your changes have been applied. In case not, then it will either show a dynamic IP address (overriding your alterations) or simply IPlocating.com will certainly not load.

- Alter your TCP and IP Settings on Windows Vista:

1. Go to the Control Panel from the Start menu.
2. Simply click "Network and Internet" and after that "Network and Sharing Center."
3. Click on "Manage network connections."
4. Pick which Internet connection you would probably like to change if you have got more than one. Right click on it and choose "Properties."
5. Simply click the "Networking" tab.
6. Select either Internet Protocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6).
7. Click "Obtain an IP Address Automatically" in order to totally reset your IP address automatically, then click OK.
8. Click "Use the following IP Address" to provide your own IP configurations.
9. Enter your IP address in the boxes marked "IP Address," "Subnet Mask" (or "Subnet prefix length for IP/TCPv6) and "Default gateway."

- Modify your own DNS Server Configurations:

1. Simply click "Obtain DNS Server Address Automatically" and after that click on "OK."
2. Click "Use the following DNS Server addresses" to modify your own DNS Server settings manually.
3. Enter your main DNS Server address into the box that says "Preferred DNS Server."
4. Type your secondary DNS Server address into the box that says "Alternate DNS Server."

- Add a New Network Protocol:

1. Simply click "Properties" and and then "Install" from "Manage network connections."
2. Simply click "Client," "Service" or "Protocol," based upon on which you wish to add. Then simply click "Add."
3. Select the item you want to include from the dialogue box and click OK.

Article Source: http://interpret.zar.vg